18
Controls, Systems and Operations
Model C723
Menu Options
Press the ARROW keys to move up or down
through the Menu. Select a Menu option by pressing
the SEL key. Exit the Menu program by selecting
“EXIT FROM MENU” or pressing the CONE
symbol .
The following menu options are listed in the
Manager's Menu.
EXIT FROM MENU
SERVINGS COUNTER
SET CLOCK
AUTO START TIME
STANDBY MODE
MIX LEVEL AUDIBLE
FAULT DESCRIPTION
FAULT HISTORY
LOCKOUT HISTORY
SYSTEM INFORMATION
CURRENT CONDITIONS
NET SERVICE PIN
Selecting “EXIT FROM MENU” will exit the
Manager's Menu and return the control panel keys
to normal operation.
The SERVINGS COUNTER screen is used to reset
the servings counter to zero. The SERVINGS
COUNTER automatically resets to zero when the
machine is brush cleaned. (See Figure 13.)
SERVINGS COUNTER
00 0
> Next
Figure 13
Reset the SERVINGS COUNTER by pressing the
SEL key to advance to the next screen. Press the
UP arrow key to move the arrow (>) to “YES” and
then press the SEL key. The servings counter will
reset to zero and return to the Manager's Menu.
(See Figure 14.)
Reset Counters
ARE YOU SURE?
Yes
>No
Figure 14
The SET CLOCK option is used to adjust the control
clock date and time. The date and time may only be
changed after the freezer has been manually
cleaned, but before it has been placed in the AUTO
or STANDBY mode. The following message will be
displayed if the SET CLOCK option is selected when
the machine is not in a brush clean state.
(See Figure 15.)
SET CLOCK
12:01 2/10/2011
NO CHANGES ALLOWED
Press Any Key
Figure 15
To change the date or time, select the SET CLOCK
option in the menu. Press the UP arrow key to
advance the arrow from “Exit” to “Change” and then
press the SEL key to select the Change option.
(See Figure 16.)
SET CLOCK
12:01 2/10/2011
Change
> Exit
Figure 16
Change the time by pressing the UP arrow with the
cursor under the hour position. Move the cursor to
the minutes position by pressing the SEL key. Once
the correct minutes are entered, press the SEL key
to advance the cursor to the month.
(See Figure 17.)
SET CLOCK
12:01 2/10/2011
> Exit
Figure 17
To Next Page
Loading...
Need help?
General
