OPERATING PROCEDURES
6-7
087482-M
Operating Procedures
6
4. Place the power switch in the ON position.
Figure 6-24
5. Press the WASH key to cause the sanitizing solution
in the freezing cylinder to be agitated. Allow it to
agitate for five minutes.
Figure 6-25
6. Place an empty pail beneath the door spouts and
raise the prime plugs.
7. Momentarily pull the center draw handle down to
sanitize the center door spout.
Figure 6-26
8. When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, lower the draw handle. Draw off all the
sanitizing solution.
Figure 6-27
9. Once the sanitizer stops flowing from the door spout,
raise the draw handle and press the WASH key,
canceling the beater motor operation.
Important! You have just sanitized the freezer. Be sure
your hands are sanitized before continuing these
instructions.
131558
To Next Page
Loading...
Need help?
General
