TC Electronic Finalizer PLUS/96K - Mastering from DAT to DAT

11
Example 3
Mastering from DAT to DAT
1. Connect the Digital Output of DAT #1 to the Digital Input
of the Finalizer.
2. Connect the Digital Output of the Finalizer to the Digital
Input of DAT #2.
Using the Finalizer with ADAT and BRC
1. Connect the Finalizers optical out to the ADATs optical in.
2. Connect the ADATs optical out to the Finalizers optical in.
3. Enter the In section of the Finalizer (Main page) and set the
"Clock" to "ADAT".
This will force the Finalizer to follow the clock of the ADAT.
Note: This is only possible when using the Analog Inputs of the Finalizer.
Example 4
FINALIZER SETUP