Need help?Do you have a question about the TC Electronic M300 and is the answer not in the manual?
Power| mains voltage | 100 to 240 VAC, 50 to 60 Hz (auto-select) |
|---|---|
| power consumption | <15 W |
Operating Environment| operating temperature | 32° F to 122° F (0° C to 50° C) |
|---|---|
| storage temperature | -22° F to 167° F (-30° C to 70° C) |
| humidity | Max. 90 % non-condensing |
Weight and Dimensions| dimensions | 19" x 1.75" x 4.2" (483 x 44 x 105.6 mm) |
|---|---|
| weight | 3.3 lb. (1.5 kg) |
Covers reading instructions, water usage, cleaning, ventilation, heat sources, plugs, cords, attachments, unplugging, and servicing.
Addresses grounding, voltage, plugs, confined spaces, opening unit, EMC/EMI, and FCC rules.
Unpacking, safety, registration, understanding engines, routing options, and initial control settings.
Uses M300 as a digital insert effect in a harddisk recording system via S/PDIF.
Utilizes M300's superior converters for high-quality A/D conversion in recording.
Explains INPUT knob, 1/L-2/R LEDs, DIG. IN, and Dual S/R LED.
Details setting delay tempo via TAP/TIMING and controlling parameters with knobs.
Covers selecting reverb types and adjusting PRE DELAY, DECAY, and COLOR.
Explains the two preset modes (On/Off) and how to toggle between them.
Guides on loading previously stored presets and saving current settings.
Explains TIMING knob for tempo and FEEDBACK knob for repeats.
Describes the Dynamic Delay effect, adjusting output by input dynamics.
Introduces compression and its parameters like Threshold, Ratio, and Attack.
Details M300 compressor (Drive/Ratio) and De-Esser (Amount/Frequency) controls.
Explains backing up presets via Bulk Dump and factory reset procedure.
To Next Page
