27
MULTI-EFFECTS
De-Esser
A De-Esser is a compressor type used to
reduce only specific sibilant frequencies.
Typically the “s” sounds can be far too
dominant in a vocal track and the track would
therefore often benefit from being processed by
a De-Esser.
The M300 Compressor
For optimal “ease of use” we have simplified
and reduced the conventional Compression
controls into the following controls:
Drive (
TIMING KNOB)
The higher the Drive setting is, - the lower
the Threshold point is set and the harder
you will “hit” the Compressor. In other words:
The higher Drive setting, the more
compression is added.
Ratio (
FEEDBACK/DEPTH KNOB)
This parameter sets the amount of gain
reduction of signal above the “Threshold” -
see Drive parameter.
De-Esser Controls
Amount (TIMING KNOB
)
Sets the amount of gain reduction around
the Frequency specified by the Frequency
knob.
Frequency (
FEEDBACK/DEPTH KNOB)
Sets the Frequency around which you would
like to reduce frequencies.
Auto Make-up gain
Since the Output of the signal above the set
Threshold point is reduced the entire signal will
appear to be at a lower volume. In many
Compressors and also in the Compressor type
used in the M300, Auto Make-up gain will
compensate for this loss of gain.
This way the Output level is kept and only the
dynamic range is changed.
To Next Page
Loading...
