TC Electronic M300 User Manual

8
REAR PANEL
Balanced
Jack
Analog
Inputs
Pedal
Input
MIDI
In/Out
Routing Switch
Balanced
Jack
Analog
Outputs
Digital
S/PDIF
Input/
Output
Power
Input
100 - 240V
ROUTING switch
Switches between Dual Send/Return and Serial
Input modes.
Dual Send/Return mode:
Switch is In, and Green LED on front is On.
Serial mode:
Switch is Out and Green LED on front is Off.
Read much more about these Routing options
on pages 22/23. See also the suggested
setups at pages 10-15.
Analog Input
Analog Input on 1/4 inch connectors.
Use Left Input for connecting a mono signal.
If you connect to Left Input only and use
Dual Send Return mode the Input signal
is fed to both the Multi-effects Engine
and the Reverb Engine, and you can then use
the M300 as two independent effect units with a
common Output.
Analog Output
Analog Output is a Stereo Output on two 1/4”
Jack connectors.
Pedal Input
The Pedal Input gives you the possibility to
Bypass and “tap” the Global Tempo via
momentary switches. The Global tempo can be
used to set Delay time.
The connection is a 1/4” Stereo Jack with
Bypass on tip and Tap Tempo on ring.

TC Electronic M300 Specifications

Power

mains voltage	100 to 240 VAC, 50 to 60 Hz (auto-select)
power consumption	<15 W

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity	Max. 90 % non-condensing

Weight and Dimensions

dimensions	19" x 1.75" x 4.2" (483 x 44 x 105.6 mm)
weight	3.3 lb. (1.5 kg)