TC-Helicon Voicelive 2 User Manual

DUCKING AMOUNT
This sets how much attenuation (gain reduction) is
applied to the delayed signal when a vocal is present.
For ducking to not be too obvious, a slight reduction of
-6 dB is best. The DUCKING parameter must be set to
ON for this to have any effect.
DUCKING TIME
Ducking time sets how long it takes to ramp up the delay
level at the end of vocal phrases.
LEAD TO DLY
Sets the amount of lead voice sent into the Delay block.
HARM TO DLY
Sets the amount of harmony level sent into the Delay
block. The HARMONY footswitch must be on to feed
this send.
UMOD TO DLY
This allows you to feed the delay block with the effected
output of the μMod block. The μMod footswitch must
be on to feed this send.
LEAD LEVEL
Controls the lead (dry + Tone) voice level when
the individual effect is turned on with its respective
footswitch. This allows a unique wet/dry mix for
individual effects. When multiple effects are active, the
lowest LEAD LEVEL value will determine the value.
Note that the LEAD EFFECT SENDS parameter on the
PRESET tab must be set to PRE in order for any signal to
get to the effect block when LEAD LEVEL is set to OFF.
The Edit Menu: DELAY Tab
59

TC-Helicon Voicelive 2 Specifications

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity	Max. 90 % non-condensing

Power

external power supply mains voltage	100 to 240 VAC, 50 to 60 Hz
power consumption	<14 W

Analog Inputs

mic input impedance	2.14/1.07 kOhm
line input impedance	13/6.5 kOhm
guitar input impedance	1 MOhm

Analog Outputs

output impedance	100/50 Ohm
output range	16 dBu / 0dBu
dynamic range	> 109 dB, 20 Hz to 20 kHz

Weight and Dimensions

dimensions	13.8" x 3" x 8.5" (350 x 76 x 216)
weight	5 lb. (2.3 kg)