TC-Helicon VoiceLive Touch 2 User Manual

The Loop Menu
38
The Loop Tools page
1
2
3
1. Selected loop waveform display
2. Loop Tools
3. Current Loop FX assignment
Also see the “Loop page” and “Metronome page” section in the
Setup menu chapter for additional loop configuration options.
Note that there are MIDI CCs that can remotely control the
looper as well.
The following sections add detail to the tutorials in the
VoiceLive Touch 2 Quick Guide. The order is from simple to
advanced operation.
Recording a basic loop
– Press the Home button.
– Find a preset you like using the Slider FX bar.
– Prepare a short rhythmic phrase before recording – for
example, singing “Boom” and “Cha” a few times.
– When you’re ready, press the Record button on your sung
downbeat (“Boom”).
– After singing the phrase a few times (multiples of 2 is best),
press the Record button again to set the loop point and
hear the loop play back.
This is your basic loop. Now you can sing over it while it
plays.

TC-Helicon VoiceLive Touch 2 Specifications

General

Type	Vocal Effects Processor
Form Factor	Tabletop
Number of Channels	1
Vocal Effects	Yes
Looper	Yes
Phantom Power	Yes
MIDI I/O	In/Out
Outputs	2 x XLR
Control	Touchscreen
Power Source	12V DC Power Supply
Inputs	1 x XLR, 1 x 1/4"