HM10 Home AC Charger Mobile Application (APP) User Guide
4) On the next page (E in Figure 3.2), enter the name (Wi-Fi SSID) and password of your
home Wi-Fi hotspot.
5) Click on “Save and Restart” button at the bottom (F in Figure 3.2) to save the configuration
and reboot the charger.
After successful configuration, your TCHARGE
®
HM10 charger will reboot first, then you will see
the Wi-Fi connection icon appear on the charger’s screen display. The LED light signal will also give
out indications of network connected status in some scenarios. You may refer to TCHARGE
®
HM10
AC Charger Installation Manual document for more details.
4. Binding a Charger
4.1 Bind Your Charger to Your Account
After set up the Wi-Fi network connection on your charger, you may now bind your charger to your
TCHARGE
®
home charging APP account to control it remotely.
This is easily done with the following steps:
1) On the Homepage of the TCHARGE
®
home charging APP, click on “Bind Your Private
Charger” button (marked as A in Figure 4.1) to open Bind Your Charger page (Figure 4.1
right).
You can also access this feature from My Chargers option in About me tab (also
refer to Figure 4.2 below).
2) Enter the charger code by scanning the QR code found on the label on the side of the
charger with the scanning function (B in Figure 4.1).
This will be the same code used for connecting to charger hotspot if you have
used that feature as described in Step (3), Part 3.
3) You can choose to nickname your charger here for better identification purposes. (This
nicknaming step is not compulsory for using the charger, but it is highly recommended.)
4) Click on “Confirm” button (C in Figure 4.1) to finish binding your charger.
To Next Page
Loading...