END OF SEASON
If the air conditioner is not going to be used for an extended period:
• Set in fan mode on a slightly warm day so that the inside of the appliance dries out.
• Switch off the power at the fuse box and remove the batteries from the remote control.
• Clean the filters.
• Remove the batteries from the remote control.
• Disconnect the power from the appliance
START OF SEASON
If the air conditioner is to be used again after an extended period:
• Check that the air intake and exhaust openings of the interior and exterior units are not
blocked. Remove any dirt or debris that has accumulated.
• Check that the filter is installed within the indoor unit and is clean.
• Check that the condensation outlet drains properly and there is no dirt or organic blockage
(otherwise leakage may occur)
• Install 2 AAA batteries in the remote control.
• Check that the wiring between the cassette and the panel is connected, and there is no
damage to the interconnecting wires.
• Turn the appliance on, set the time and desired setting.
REPLACING THE BATTERIES
• Remove the cover from the rear of the remote control.
• Replace the AAA batteries, ensuring the correct polarity.
• Reinstall the cover on the rear of the remote control.
• The display on the remote will start to alternate between the
HEAT and COOL symbols. Press any button on the remote when
the HEAT symbol is displayed to set the remote up for heating and
cooling.
• If nothing is displayed on the remote, try pressing the power
button. If still no response, check the polarity of the batteries and
try replacing.
To Next Page
Loading...
Need help?
General
