Product Registration
Please register your purchase on-line at www.TCLUSA.com. It will make it easier to contact you should it ever be necessary. Registration is not
required for warranty coverage.
Product Information
Keep your sales receipt to obtain warranty parts and service and for proof of purchase. Attach it here and record the serial and model numbers
in case you need them. These numbers are located on the product.
Model No. ____________________________________________
Serial No. _____________________________________________
Purchase Date ________________________________________
Dealer/Address/Phone __________________________________
Important safety instructions
1. Read instructions. Read all the safety and operating instructions before operating the product.
2. Retain instructions. Retain the safety and operating instructions for future reference.
3. Heed warnings. Adhere to all warnings on the product and in the operating instructions.
4. Follow instructions. Follow all operating and use instructions.
5. Water and moisture. Do not use this product near water.
6. Cleaning. Clean only with a dry cloth.
7. Ventilation. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Heat. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Grounding or polarization. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of
the obsolete outlet.
10. Power cord protection. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where it exits from the product.
11. Accessories. Use only attachments/accessories specified by the manufacturer.
12. Stand/cart. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from
tip-over.
13. Power. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Servicing. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way,
such as power-supply cord or plug damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been dropped.
15. If an outside antenna or cable system is connected to the product,
be sure the antenna or cable system is grounded so as to provide
some protection against voltage surges and built-up static charges.
Section 810 of the National Electrical Code, ANSI/NFPA No. 70-2011
(Section 54 of Canadian Electrical Code, Part 1) provides
information with respect to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna-
discharge unit, size of grounding conductors, location of antenna-
discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode. See following example:
To Next Page
Loading...
Need help?
General
