TCS ISW3130 User Manual

07/2015 15
TCS TürControlSysteme AG Subject to technical changes.
E-Mail: hotline@tcsag.de • www.tcsag.de PI_ISW3130-uk 2 A
1
Initiate
power supply and control unit
RUN/PROG push
Button: press short LED blinks
programming mode of the system is switched on
2
Delete a button
a)
press until the delete-tone-melody sounds
1)
release
3
Programming via voice connection
or
establish voice communication
to the front-station
2)
shortly press
the button
... a ring tone sounds at the front-door
and indoor station
1)
4
End
power supply and control unit
RUN/PROG-push
button: shortly press LED is ON
programming mode of the system is switched off *
)
a) Not necessary, if the bell buttons have not been programmed, comp. product information of the front-door station.
1) If there sounds a Progsperr tone instead, the front-door station is equipped with a programming lock.
The programming lock can be deactivated only with the Service Device TCSK-01 or the configuration software
configo™.
2) New developed front-door stations (as of 2009) respond to that with a positive acknowledgement, if the serial number
of the indoor station was received (see product information of the front-door station).
*) for device specific indication modes of t he front-door station see product information of the front-door station
Cleaning
!
Avoid water from entering the device!
Do not use any abrasive detergents!
Clean the device with a dry or slightly moist cloth.
Remove stronger stains with a mild plastic cleaner.

TCS ISW3130 Specifications

General

Brand	TCS
Model	ISW3130
Category	Intercom System
Language	English