TE Connectivity T6112DS - Print Parameters

26 26
9.3 Print Parameters
 Press the menu button.
 Select Setup > Print param..
Parameter Meaning Default
Heat level
Heating value for compensating for the differing thermal behavior of
printheads. Changing this value is then especially necessary if the
printing intensity has changed after replacing the printhead.
 To adapt the printing intensity when using different media, print
speeds or printing contents, you should change the heat level in
the software.
The settings from the Print param. menu and the software are
added together.
The Heat level setting also affects the test printouts.
+5
Print speed
Basic print speed setting.
The print speed can be re-specied for each print job via software.
The basic setting is not changed by this.
The print speed setting also affects the test printouts.
100 mm/s
Transfer print
On for thermal transfer printing: Sensor for monitoring the transfer
ribbon is activated.
Off for thermal direct printing: Sensor for monitoring the transfer
ribbon is not activated.
The setting can be overwritten for each print job via software. The
basic setting is not changed by this.
On
Warn level
ribbon
Warning via the Ethernet interface by way of an SNMP message or
e-mail sent when the remaining diameter of the ribbon supply roll
undershoots the set value (32–74 mm).
Off
Label sensor
Method for detecting the starting end of the label.
Gap Sensor: Detection using changes in the transparency between
the label and label gap.
Bottom-Reect: Detection using reex marks on the bottom of the
medium.
Continuous media:
Synchronization of the paper ow when using endless media in
cutting mode.
 After loading media press the feed key.
That way a short feed and a synchronization cut are realized.
Gap
sensor
Tear-off mode
Positioning the label medium for tearing off at the tear-off plate.
On: Additional advancement of the label medium which positions the
label gap after the last printed label at the dispense plate.
Off: Label advance stops once the last label has fully passed the
print line.
Off
Backfeed
Method for backfeeding the label medium.
Backfeeding is necessary in the cutting and peel-off modes since a
label is pushed out passed the front edge of the next label above the
print line when peeling off/cutting.
always: Backfeeding occurs independently of label contents.
smart: Backfeeding only occurs when the next label is not yet fully
prepared when peeling off/cutting the current label. Otherwise, the
second label is pushed on and completed after removal of the rst
label without backfeeding.
smart
Error-Reprint
On: With a correctable error and corresponding troubleshooting, the
label being printed when the error occurs is repeated.
Off: Print job is continued with the next label.
On
9 Conguration