Teac A-400 - Page 26

ASSEMBLING HARDWARE CODING L13T
All screws conform to ISO standards, and have cross-recessed
heads, unless otherwise noted.
ISO screws have the head inscribed with a point as in the figure
to the right.
FOR EXAMPLE :
in
Uhewentoedacetenese
Length
in
mm
(L)
L
ale
ecetescte
rans
Diameter
in
mm
(D)
L
ietataiataalatatatatetatatetatatatanty Type of Head
lp
~
cS
iv)
Code Full Name Full Name Type
Binding Head
Tapping
Screw(A
Type)
LD
&
R Round Head Screw
P Pan Head Screw Binding Head ea
Tapping Screw(B Type)
Round Head
Tapping Screw(A Type)|
Round Head
Tapping Screw(B Type)
Stove Head Screw
(Truss)
lf
MACHINE
: SCREW
Binding Head Screw
@
j
Hex Socket
Setscrew( Flat Point)
Flat Countersunk
Head Screw
4
Hex Socket
Oval Countersunk
SETSCREW Setscrew( Cup Point)
Head Screw
Slotted Socket
Setscrew( Flat Point)
—
Ye E-Ring
(Retaining Washer)
Round Head
Wood Screw
Flat Countersunk
Wood Screw
ow Oval Countersunk
Wood Gore Pitti Flat Washer (Plain)
Binding Head
BSA SEMS Screw(A Type) Lock Washer ( Spring)
WASHER
Lock Washer
Binding Head
(internal Teeth)
BSB SEMS Screw(B Type)
Binding Head
Lock Washer
BSF | seMs Screw(F Type)
(External Teeth)
Trim Washer
(Countersunk)
Pan Head
PSA | sems Sorew(A Type)
C=
¢ o>
PSB Pan Head
SEMS
Screw(B
Type)
Hex
Nut