PREFACE&SAFETY SUMMARY
2
Precautions on Electromagnetic Wave Interference
（1）Possible Electromagnetic Wave Interference Caused by This Instrument
When this instrument is used in a residential area or an adjacent area
thereto, it may cause interference to radio and television reception.
To prevent this, use the specified system connection cables in strict
accordance with the instruction manual. The instrument is designed to
minimize possible electromagnetic wave interference caused by it if the
specified cables are connected properly.
However, there is no guarantee that electromagnetic wave interference will
not be caused by the instrument. If the instrument does cause
interference to radio or television reception, which can be determined by
turning off and on the instrument, the user is encouraged to try to correct
the interference by one or more of the following measures:
Increase separation between the instrument and radio/TV receiver.
Connect the instrument to an outlet on a circuit different from that to
which the radio/TV receiver is connected.
（2）Possible Electromagnetic Wave Interference Affecting This Instrument
If this instrument is used near an intense electromagnetic source,
interference noise may be given to the instrument to incur an adverse effect
on its performance or functionality.This effect will be less than 1% and still
could be accepted.
To prevent this, use the specified system connection cables in strict
accordance with the instruction manual. The instrument is designed to
minimize possible electromagnetic wave interference affecting it if the
specified cables are connected properly.
However, there is no guarantee that electromagnetic wave interference will
not occur in this instrument. If the instrument does incur electromagnetic
wave interference, which can be determined by turning on and off possible
sources of electromagnetic wave interference nearby, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient the instrument.
Increase separation between the instrument and possible sources of
electromagnetic wave interference.
Increase separation between the power cable of the instrument and
possible sources of electromagnetic wave interference.
Connect the instrument to an outlet on a circuit different from that to
which possible sources of electromagnetic wave interference are
connected.
Confirm that any other device connected with the instrument is not
affected by electromagnetic wave interference.
To Next Page
Loading...