Techcomp UV 2600 - Storing of Instrument; After Test Is Finished; Instrument will Not be Used for a Long Time

CHAPTER 4 MAINTENANCE
47
4.6 Storing of Instrument
4.6.1 After Test Is Finished
(1) Turn off the instrument. Pull out the plug of power cord.
(2) Cover the instrument with dustproof cover.
△Note
If there are corrosive, volatile organic solvent or venomous sample in the
sample compartment, be sure to take them out.
4.6.2 Instrument Will Not Be Used for a Long Time
(1) Please do not place the instrument in the place with high temperature
(more than 70℃), low temperature (less than -20℃), high hunidity (more than
80%), or vibrant source.
(2) Make sure to cover the dustproof cover on the instrument.
(3) Instrument cannot be touched to corrosive and venomous gases.
(4) When instrument is being transported to storage place, fix the viewfinder by
sponge.
(5) Do not keep the instrument in electromagnetism field place.
(6) Do not keep the instrument in dusty place.
(7) Avoid direct sunlight to the instrument.