14
Chapter3 Operation Guide
3.1 Operation through Web Management System
3.1.1 Assigning IP Addresses
The equipment is equipped with a 10/100Base-T port for communication with a remote control
and monitoring PC.
When the equipment leaves our factory, the Ethernet port is configured with the following
parameter settings:
Before the equipment can be connected to a LAN, the default IP settings of the equipment must
be changed to correct values according to the actual network environment.
1. Setup a connection between the device and monitor PC.
Note: Step 1 to Step 2 is operated from the front panel. There are six buttons on the
front panel: Up / Down / Left / Right / Menu / OK for you to manually configure the
basic parameters of the device.
Step 1: Check out the device IP
Press MENU button to enter main menu.
Press UP button and DOWN to navigate to the sub menu System.
Press OK to Enter the Sub menu Ethernet Setup, within it, press UP button and DOWN
button, you can check out the IP, Gateway, Subnet Mask, etc.
Step 2: Change the IP, Gateway and Subnet Mask to make it in the same network
section as the management PC:
Example:
To Next Page
Loading...