18
(2) Information Window: This part showing the specific information according to your
selection in the tool bar. You can set the parameter of the chassis and sub-modules as well
as the business logic of the services in this page.
3.1.3 Basic Operation Introduction
3.1.3.1 Service Configure Introduction:
Below content introduce the basic configuration of the service business logic in the service
configuration page:
① Input Program Configuration: the “Input Program Configuration” is on the left side of the
“Program Info” window. It displays all the inserted modules information and the received
input streams.
1. Scan the input TS: after the parameters of the inserted module are properly configured,
select one port which is connected with input stream, and then click the mouse right button. If
the input stream complies to DVB standard, please select “Scan TS (DVB)”; If the input stream
complies to ATSC standard, please select “Scan TS(ATSC)”. All the input stream of that port
will be scanned and displayed. Click “Clear TS” to clear all input programs of this port if needed.
To Next Page
Loading...