5
The mounting surface or rack should be appropriately anchored according to manufacturer's
specifications. Ensure this equipment is securely fastened to the mounting surface or rack
where necessary to protect against damage due to any disturbance and subsequent fall.
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis
using the handles on modules (such as power supplies, fans, or cards); these types of
handles are not designed to support the weight of the unit.
Installation of this equipment in a rack should be such that the amount of airflow required for
safe operation of this equipment is not compromised.
Only install this equipment in a humidity- and temperature-controlled environment that
meets the requirements given in this equipment's technical specifications.
AC Power
This product requires short-circuit (overcurrent) protection to be provided as part of the
building installation. Install only in accordance with national and local wiring regulations. The
outlet must be near this equipment and must be easily accessible.
Connect this equipment only to the power sources that are identified on the
equipment-rating label normally located close to the power inlet connector(s).
The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device.
Always pull on the plug or the connector to disconnect a cable. Never pull on the cable itself.
Unplug this equipment when unused for long periods of time.
Circuit Overload
Know the effects of circuit overloading before connecting this equipment to the power supply.
Take care when connecting units to the supply circuit so that wiring is not overloaded.
WARNING:
Consideration should be given to the connection of this equipment to the supply
circuit and the effect that overloading of circuits might have on overcurrent protection
and supply wiring. Appropriate consideration of information given on the
equipment-rating label should be used when addressing this concern.