126
11 INTERNET SECU
RITY
E-DOC-CTC-20100728-0008 v2.0
Option 1: content-based filter (combined with the address-based filter)
If you want to use the content-based filtering:
1 Browse to the Technicolor Gateway GUI.
2 On the Toolbox menu, click Web Site Filtering.
3 On the Navigation bar, click Configure.
4 Make sure that the Use Content-Based Filter check box is selected.
5 Configure the content-based filter. For more information, see “11.2.1 Configuring Content-based Filtering” on page 127.
6 If you want to make exceptions for specific web sites, add the necessary rules in the address-based filter. For more
information, see “11.2.2 Adding Rules for Address-Based Filtering” on page 128.
Option 2: address-based filter only
Take this option if content filtering is not available on your Technicolor Gateway or you don’t want to use it.
To configure address-based filtering:
1 Browse to the Technicolor Gateway GUI.
2 On the Toolbox menu, click Web Site Filtering.
3 On the Navigation bar, click Configure.
4 Make sure that the Use Address-Based Filter check box is selected.
5 In the Action for Unknown Sites, select:
Allow as the default rule if you want to allow access to all web sites and manually specify which web sites may not be
accessed.
Block as the default rule if you want to deny access to all web sites and manually specify a number of web sites that
may be accessed.
6 Click Apply.
7 If you want to make exceptions for specific web sites, add the necessary rules in the address-based filter.
For more information, see “11.2.2 Adding Rules for Address-Based Filtering” on page 128.
To Next Page
Loading...
Need help?
General
