53
4 CONFIGURATION TOOLS
E-DOC-CTC-20100728-0008 v2.0
4.3.3 Access the CLI from the GUI
Procedure
Proceed as follows:
1 Browse to the Technicolor Gateway GUI.
For more information, see “4.1 Technicolor Gateway GUI” on page 42.
2 In the Display Level list, click Expert.
3 In the upper-right corner, click CLI.
4 The Technicolor Gateway CLI pages page appears:
The CLI command tree
On the left of the page, you can find the command tree. This tree contains all CLI commands that are available for
configuration.
Command types
The commands are three types of commands that can be identified by the icon displayed next to the command:
Icon Description
Command group
Function that does not require input. The results are immediately displayed.
Function that requires input. When you click on this function, a page will appear where you can enter the
parameters.
Parameters that are required will be explicitly labelled as required.
To Next Page
Loading...
