28
3 MANUAL INSTAL
LATION
E-DOC-CTC-20100728-0008 v2.0
3.1.2 Setting up your Technicolor Gateway as Local Router
Procedure
Proceed as follows:
1 Take an Ethernet cable. If your box contains an Ethernet cable with red connectors, you can use that cable.
2 Plug one end of the cable in the red WAN port on the back of your Technicolor Gateway.
3 Plug the other end of the cable into the Ethernet port of your Internet gateway/modem.
The WAN port can only be used to connect your Technicolor Gateway to an Internet gateway/modem. You can not
use it to connect other devices (for example, a computer) to the Technicolor Gateway.
To Next Page
Loading...
