38
3 MANUAL INSTAL
LATION
E-DOC-CTC-20100728-0008 v2.0
4 Attach the newly configured PPP interface:
Step 2: Enable NAT address translation for the new PPP interface
Execute the following command:
Step 3: Save your changes!
Execute the following command:
:ppp ifattach intf=3G-Backup
:nat ifconfig intf=3G-Backup translation=enabled
:saveall
If you do not save your settings, all your changes will be lost after a powering of or restarting the Technicolor
Gateway.
To Next Page
Loading...
