90
Turning the timer on
“Play Timer Setting”
Press [ ], [ ] to select “On” and then press [OK]
to store the volume.
• The clock icon is displayed.
• “Adjust CLOCK” is displayed when the clock is
not set.
• “Adjust Play Timer” is displayed when the play
timer is not set.
Turn the unit to standby mode.
• The timer is enabled after turning this unit to
standby mode.
• At the set time, the music source starts to play
at a low volume and the volume increases
gradually to the preset level.
• To turn the timer off, select “Off” in step
(above).
Note
• This unit can be used as normal even after the
timer is set, however:
Turn the unit to standby mode before the timer
start time.
Even if the audio source or the volume is
changed, the timer will still use the audio source
and volume that was set when the timer was
turned on.
• You can set the repeat playback for “CD” or “USB”.
The favourite station registered by [FAV] can be
also played back.
• After starting the timer, this unit is turned off
automatically at the finishing time even when
using this unit as normal.
To Next Page
Loading...
Need help?
General
