Technics SA-EX 140 - Basic Operations Ach Iiccsiaceisumesinnakemseionan; To Adjust the Tome Quality; To Adjust the Sound Balance; To Mute the Sound Level Occ

Basic operations
Before operation, set VOLUME to the “MIN” position.
i Press [POWER].
Press [SPEAKERS] to select the speaker system
to be used.
Changes as follows each time the button is pressed.
SPEAKERS EY —- SPEAKERS EE] —- (OFF)
t ee ere
Speakers A and B cannot be used at the same time.
Caution
Before selecting your speaker system, make sure imped-
‘ance is correct in the speakers you want to use.
(See page 6.)
Operations =
Press to select the desired source, and start the
desired source.
(Refer to the appropriate operating instructions for details.)
VCR: To watch video tapes (VCR)
[TAPE MONITOR |: To listen to cassette tapes (The tape
monitor indicator will appear.)
(See below.)
CD: To listen to compact discs
TUNER: To listen to radio broadcasts
PHONO: To listen to phono discs
Turn VOLUME to adjust the volume level.
POOR P AE Pa Dae P RARE TE TATE FETS HEHEHE HHA oR ERR RE REESE ADEE REDE E ETE S tuehesetaaenee
After listening is finished
Be sure to reduce the volume levei, and switch the power to the
standby condition by pressing [POWER].
| When the tape monitor indicator is lit or flashing F
This indicates that the tape monitor function of this unit is ON.
To listen to sources other than a tape, be sure to press
TAPE MONITOR | and check the indicator goes out.
To adjust the tone quality E
Turn [BASS] to adjust the low frequency sound.
Turn [TREBLE] to adjust the high frequency sound.
VOLUME,
Lc)
To adjust the sound balance
Turn [BALANCE] to adjust the left/right sound balance.
To mute the sound level
Press [MUTING].
The message “MUTING ON NOW” runs repeatedly from right to left
across the display as long as the muting function is on.
Press once again to return to the previous volume level,
naeaT TANC 5 When the receiver is turned off, the muting operation will be auto-
LS S A E E matically cancelled.
RQT5221