Technics SL-B20

Stylus replacement
The replacement stylus for this cartridge is EPS-24CS.
Stylus life varies with the conditions of use.
Noise or scratchiness may indicate a worn or damaged stylus.
Stylus replacement is recommended after about 1000 hours of
playing time. Holding the sides of the stylus assembly, pull out
to remove the old stylus. Line up the new stylus assembly with
the cartridge and push in firmly so that the stylus is securely in
place. (Fig. 18)
Notes:
@Be very careful not to touch the stylus tip or cantilever
during above procedures.
e@There should be no gap between the stylus assembly
and the cartridge body.
Cartridge replacement
Plug-in connector cartridges are now available from
Ortofon (Denmark), Shure (U.S.A.), Audio Technica
(Japan) as well as from Technics. All of these cartridges are
designed for perfect matching with this turntable in all areas
including weight, tracking force, stylus tip position, and
center of gravity. Therefore, you have the option of
employing a wide range of cartridges from the world’s top
manufacturers without the trouble of lead wire connections
or tracking force adjustment.
1, Attach the tonearm'o the arm rest with the tonearm clamp.
2. Remove the cartridge attachment screw. (Fig. 19)
3. Carefully pull the cartridge out from the tonearm being sure
you don’t touch the stylus. (Fig. 26)
4. Align the pins on the new cartridge with the tonearm
connector and plug it into the tonearm as far as it will go.
5. Tighten the cartridge attachment screw.
Notes and maintenance
™ Do not touch or hold the tonearm during automatic
operation.
@ Carefully remove dust and dirt from records and stylus.
(Fig. 21)
Dust and dirt degrade sound quality and cause excessive
wear of the stylus and grooves.
@ Wipe the dust cover and turntable base with a soft, dry
cloth.
Never use volatile cleaners such as alcohol, benzine or
thinner.
Do not use chemically treated dust cloths. Do not expose the
cover to insecticide spray.
To remove stubborn spots, first pull out the AC plug and
detach the cover.
Then wipe the cover with a soft cloth slightly moistened with
a mild soap and water solution.
Do not wipe the cover during play, or the tonearm may be
attracted toward the cover due to the generation of static
electricity.
@ Transporting and shipping the turntable
Pack the unit in the reverse order from unpacking. Use the
original packing material if possible. Otherwise, take these
steps:
eRemove the platter and mat and wrap them.
@Tape or tie the tonearm to the arm rest so it cannot shake
free.
Wrap the turntable base with a blanket or soft paper to
avoid scratches or damage.
@ Howto remove and install the turntable platter
The belt is connected to the capstan and the inner drive rim
of the platter.
Before removing the platter, release the belt from the
capstan.
When reinstalling the platter, lower it over the turntable
shaft and then put the belt onto the capstan.
Note:
Be careful not to let oil or grease contact the belt.
If grease inadvertently contacts the belt, disconnect the
AC power plug first and wipe the belt clean with alcohol.