Technics SL-P202A - Page 16

SL-P202A
e 10403 (MN1551 PJF-1):
1/0
Division
Function
Power supply (connected to +5V)
|
1/0
Division
Function
Not connected
Not connected
Track loss signal
Radial error digital
Command signal of access mode
Not connected
Radial error digital divided by four
Speed control code output
Period det. select signal output
Period det. setect signal output
Not connected
—
Not connected
Not connected
Not connected
Not connected
Reset command
Period det. select signal output
Track loss det. signal output
192 fs (8.4672 MHz) clock input
e 1C601 (MN15283PEY—1): System control and FL drive
3 x1 !
VO
eo ene
Optical servo condition input
(Not used, open)
1/0
Division
GND terminal
Function
= [retest oon
Key scan signa!
00 (RECV)
Data receipt command signal
O1 (SEND)
Data transmission command signal
O02 (ACK)
Data discrimination signal
Key return signal
Not used, open
O3 (CLK)
Data lock signal
10 (D0)
Q
13 (D3)
Key scan signal
SYNC
RST
Not used, open
Reset command (reset at “L"’)
IRQ/TC1 Remote control signal input
50
Q |
53
Key return signal
Sub-code frame clock (7.35 kHz)
(Not used, open)
te
Sub-code Q data input
(Not used, open)
Key scan signal
Key scan signal
Not used, open
_ Not used, open
Not used, open
Not used, open
FL drive power supply
(connected to —28.3V)
FL grid signal
FL anode signal
Power supply (connected to +5V)
Clock terminal
= TBS
Clock input