13
TURNING THE UNIT ON
When the AC power cord is connected, press the STD.BY/ON button on the unit to turn it on.
Press the FUNCTION button to select the desired mode (DTV, TV, DVD, AV1, AV2/SCART or PC).
If you select DVD, the DVD logo will appear on the screen.
Note :
When the unit is not going to be used for a long time, disconnect the AC
power supply cord from AC outlet.
TURNING THE UNIT ON FOR THE FIRST TIME (DTV mode)
The first time for you turn on the unit, it will start in DTV mode. You can simply follow the on
screen prompt to set up the system.
1. Make sure the RF aerial has been connected to the TV ANTENNA input on the rear of the TV.
2. Press the FUNCTION button or the TV/DTV button to select DTV mode. DTV Set-up menu
appears.
3. Press the ENTER (OK) button to enter the Set-up menu. The system will automatically start to
scan and preset all available DTV channels.
4. After scanning finished, the TV will display the first stored DTV channel.
UNIT OPERATION
SELECTING TV MODE FOR THE FIRST TIME
1. Use the or button to select the Country you prefer.
2. Use the
button to select Auto tune.
3. Press
button. The system will automatically start to scan and preset all available TV
channels.
4. After scan and storing has finished, the TV will display the first stored channel.
Press to set-up services on your receiver
OK
CN Name Provider Type
No services currently stored
FULL SCAN REPLACE EXISTING SERVICES
Please wait while scanning ... 3 minutes remaining
0% 100%
13-17-1.pmd 10/22/2007, 3:46 PM13
To Next Page
Loading...
