To Next PageTo Next Page
Need help?Do you have a question about the TechnipFMC Smith Meter H8 and is the answer not in the manual?
General| Model | H8 |
|---|---|
| Manufacturer | TechnipFMC Smith Meter |
| Category | Measuring Instruments |
| Size | 8 inch |
| Accuracy | ±0.15% of reading |
| Repeatability | 0.02% |
| Pressure Rating | 150 psi |
| Operating Temperature | -50°F to 250°F (-46°C to 121°C) |
| Materials of Construction | stainless steel |
| Body Material | Cast iron |
| Rotor Material | Aluminum |
| Bearing Type | Ball bearings |
| Output | Pulse or 4-20 mA |
| Certifications | OIML |
Details adjustment procedures for rotor end clearance on various meter models.
Details how to measure clearance between blades and rotor slots.
Describes measurement of blade tip position relative to rotor bottom surface.
Explains how to measure clearance between blade tip and meter housing.
Details how to measure clearance between the rotor and the block.
Describes measuring clearance between blade roller and cam radius.
Details the procedure for adjusting rotor total end clearance.
Details setting rotor end clearances by adjusting the rotor adjusting screw.
