Exiting the installation wizard
Confirm the final message from the installation wizard by pressing the OK button.
7 Operating the unit
7.1 Switching on
> Switch the digital receiver on by pressing the On / standby button either on the
device or on the remote control.
7.3 Switching off
> Press the On / Standby button either on the device or on the remote control to
switch the device off again.
> The receiver is now in ready mode (standby). Therefore, the time is displayed in the
receiver's display panel if activated (Point 8.2.4 in your operating manual).
If the time is not displayed, this still needs to be acquired by the receiver. To do this,
switch the receiver on and set it to receive e.g. ZDF for approx. 30 seconds to
automatically acquire the time.
7.4 Selecting a channel
7.4.1 Using the channel up / down buttons
> Use the up / down arrow keys on the receiver to select a channel, or use the
Channel + / - buttons on the remote control to scroll up or down the channel
settings.
7.4.2 Using the numeric pad keys
> Use the numeric keypad keys to enter the number of the channel you want.
For example:
1 for channel slot 1
1, then 4 for channel slot 14
2, then 3, then 4 for channel slot 234
1, then 5, then 6 then 7 for channel slot 1567
When entering channel numbers with multiple digits, you have approx. three seconds after
pressing a key to complete the entry.
32
To Next Page
Loading...
Need help?
General
