TechniSat DIGIT ISIO STC User Manual

18 Troubleshooting guide
55
Check Dolby Digital /
language selection
(see Point 9.7)
Check zoom setting
(see Point 9.12)
No picture, no sound,
display not on
No mains voltage Check mains adapter and
plug
No picture via HDMI Configured HDMI resolution
is not supported by TV
Correct HDMI resolution
(see Point 8.3.3)
No sound via HDMI,
picture OK
Wrong HDMI sound format
selected
Check HDMI sound format
(see Point 8.4.5)
No sound or wrong audio
playing
Dolby Digital active or wrong
audio language selected
Check setting in menu
(see Point 8.4.1 and Point
8.4.3)
Wrong picture display /
zoom selected
Check picture display /
zoom in the menu
(see Point 8.3.2)
Picture not fully visible or
distorted
Picture format not correctly
set
Check picture format
(see Point 8.3.1)
Batteries are spent Replace the batteries
(see Point 3.5)
Various channels not shown
in channel list
Wrong channel list selected Select a different channel
list (see Point 9.4.3.1)
Channels such as DSF and
Tele 5 have interference at
certain times on
On account of “DECT
Telephones” (radio
telephones)
Increase distance between
base station and receiver
Sound OK, no TV picture Radio mode called up and
radio background image is
switched off
Check setting
(see Points 8.8.1 and 9.4.7)
Fault Possible cause Remedy
Remote control does not
work
Wrong remote control code
used
Set the correct remote
control code
(see Point 8.2.5)

TechniSat DIGIT ISIO STC Specifications

General

Brand	TechniSat
Model	DIGIT ISIO STC
Category	TV Receiver
Language	English