6.4
Inserting batteries into the remote control
>
Open the battery compartment on the back of the remote control by sliding it
in the direction of the arrow.
>
Insert the batteries (2x AAA 1.5V) into the battery compartment
according to the polarity shown in the battery compartment.
>
Carefully close the assembly compartment cover again so that the
retaining tabs of the cover engage in the housing.
Notes:
-
To operate the remote control, you need 2x alkaline batteries, type Micro,
1.5 V, LR03/AAA. Make sure the polarity is correct when inserting the
batteries.
-
Replace weakening batteries in good time.
6.5
Connecting the headphones
ATTENTION: Hearing damage!
Do not listen to music at high volume through headphones. This can lead to permanent
hearing damage. Before using headphones, set the device volume to the minimum level.
Only use headphones with a 3.5 millimetre stereo jack plug.
>
Insert the plug of the headphones into the headphones socket (18) on
the back of the DIGITRADIO 574 IR. The sound is now played exclusively via
the headphones, the loudspeakers are muted.
>
If you want to listen via the speakers again, unplug the headset from
the headset socket on the device.
6.6
Music playback from external devices
You can play music from external devices with an audio output via the DIGITRADIO
574 IR.
>
Connect the DIGITRADIO 574 IR to the audio output of the external
device using a standard stereo jack cable (3.5 mm) via the AUX-IN
(19).
7
General device functions
You can make settings and perform functions using the buttons on the appliance as
well as the remote control. The buttons on the remote control are used to operate
the device as described in these operating instructions.
To Next Page
Loading...
Need help?
General