Alternative:
>
Press the MENU button and then select [Main menu > DAB+].
When DAB+ is started for the first time, a complete station search is carried
out. The station list is then displayed (see point 11.4).
11.3
Perform
search run
The automatic search scans all DAB Band III channels and thus finds all stations
broadcast in the reception area.
Once the search is complete, the first station is played in alphanumeric order.
>
To perform a complete search, press the SCAN button.
"Search" appears on the display. The search starts and the progress bar appears
on the display. The station list is then displayed
>
After completing the channel search, press the ▲ or ▼ and OK buttons when
the channel list is displayed to select a channel.
Alternative:
>
Press the MENU button and use the ▲ or ▼ buttons to select
[Complete search]. Confirm by pressing OK.
If no station is found, check the antenna and change the installation
location if necessary (point 6.2).
11.3.1
Manual
search
If you would like to perform a manual channel scan, proceed as follows:
>
Select [MENU] > [Manual setting] and press the OK button.
>
Use the ▲ or ▼ buttons to select a station frequency and press the OK
button.
If transmitters are transmitted on the selected frequency, this is shown on
the stability bar (see also point 11.8). If these stations are not yet in your
station list, they will now be saved there.
11.4
Call up
channel list
>
You can use the station list to check and play the stations found on the
device. To do this, press the ▲ or ▼ buttons to call up the station list and
select a station.
>
To select the highlighted station, press the OK button.
>
Alternatively, you can also press the MENU button and press ▲ or ▼ >
Select
[Channel list].
To Next Page
Loading...
Need help?
General