17.10
Setup wizard
>
Press the MENU button and then select
[System settings] > [Setup wizard].
The setup wizard starts automatically the first time you switch on the device.
First select the language with ▲ /▼ and confirm your selection with OK.
>
As soon as [Execute now] appears on the display, select [YES] and
confirm with OK.
If you select [No], the wizard will close and you will have to make the
required settings manually.
You will now be guided through the settings step by step.
>
Under [Date/Time], select the desired display format for the time
display (chapter 17.4) and press the OK button.
>
In the next step, you must select the source via which the time and date are
to be synchronised (for more information, see chapter 17.4).
If you have selected [Update from Net], you must then specify the time
zone and summer/winter time.
After the time and date settings, some network settings are now made.
>
Select whether the WLAN connection should also remain active in standby mode.
Press the OK button.
>
Make sure that the device is in the reception area of the desired Wi-Fi
network and that you have the access data. In some cases, it may be
necessary to make some settings on the router. In this case, please
consult the relevant operating instructions.
After a search of the available wireless networks, the result will be
displayed.
>
Select the desired wireless network and confirm your selection with OK.
Select Skip WPS to enter the password.
If it is a protected network, you will be asked to enter the corresponding
access key.
>
To do this, select the corresponding character.
>
Then enter the selected character by pressing the OK button.
Continue in this way until the complete access key is visible in the input field.
To Next Page
Loading...
Need help?
General