17.4
Internet settings
>
Press the MENU button and then select
[System settings] > [Internet settings].
In this menu you will find some settings and information about the Internet connection.
17.4.1
Network wizard
>
Select [Network Wizard] to establish a WLAN connection. The network
wizard shows you all WLAN networks within range.
stations. Select the known Wi-Fi network with ▲/▼ and OK, select [Skip
WPS] and then enter the corresponding password using the keypad that
appears. Then select the field and press OK. If the
password is correct, a connection to this network will now be established. You
can recognise whether a connection exists by the signal bar in the status
bar of the display.
To cancel the entry, select and press the OK button. If you have
made a typing error, you can delete the last letter entered by pressing .
>
If you want to establish a WPS connection instead of entering the password,
proceed as follows after selecting the WLAN network:
Please refer to your router's operating instructions to find out how to
activate WPS on your router.
>
After selecting the WLAN network on the DIGITRADIO 574 IR, select
Press [button]. Follow the instructions on the display.
>
Start WPS on your router by pressing the corresponding button.
>
If your router only supports the WPS PIN, select [PIN] on the DIGITRADIO
574 IR and make a note of the PIN shown on the display. You must then enter
the PIN in the router.
17.4.2
WPS connection
>
Select [Internet settings > WPS setup] if your router has the WPS
function. This establishes a direct connection to the router without having to
enter the WLAN password.
Please refer to your router's operating instructions to find out how to
activate WPS on your router.
>
Start WPS on your router by pressing the corresponding button.
Follow the instructions on the display of the DIGITRADIO 574 IR.
17.4.3
Further information on the network connection
To display further information on the current connection, select
[Show
settings
].
To Next Page
Loading...
Need help?
General