Technogym Bikerace - Disassembly of Components; Display Unit Disassembly

BIKERACE: Service & Maintenance Manual - rev. 1.1
Page 7.1
7. DISASSEMBLY OF COMPONENTS
7.1. DISASSEMBLING THE DISPLAY
Figure 7.1-1
1. Turn off the machine and unplug the mains
lead from the wall outlet.
2. Back off the 5 screws a using a 4-mm hex T
wrench.
Support the DISPLAY before removing
the last screw.
Figure 7.1-2
3. Open the DISPLAY.
To remove the DISPLAY:
1. Disconnect connector c.
2. Remove the DISPLAY.
To reassemble the DISPLAY, carry out the
above steps in reverse order.