Technogym Cable Stations - Module with Double Cable Outlet

Cable Stations
23
A
B
C
Replacing the cable
Module with double cable outlet
To replace the cable, proceed in the same way for both ends of the cable:
- remove any accessories;
- raise rubber gaiter (A);
- unscrew the screws (B) and pull the cable out from connector (C);
- remove the whole cable from the product;
- insert the new cable (ensuring that it follows the same route as the original cable, as shown
in the illustration);
- t rubber gaiter (A) and attachment (C), then tighten screws (B);
- lower rubber gaiter (A)