Run 1000 - Run 600 Excite
28
Routine maintenance
Emergency button
Check the condition of the emergency push button each month:
- Ensure that the cord and the spring are present and in good condition.
- Check the condition of the emergency push button.
- With the rotating belt in motion at 5 km/h pull the cord with the spring to trigger the emergency push button and ensure that the belt stops.
- With the rotating belt in motion at 5 km/h press the emergency push button to ensure that the belt stops.
If the emergency push button does not work properly place the product out of service and contact Technogym Technical Support Service.
to replace defective or damaged components contact the Technogym Technical Support Service.
Maintenance of the running surface
The Preventive care light is located at the end of the left side handgrip, next to the moving belt indicator light.
This green indicator light indicates the wear level of the belt, and turns on during standby; it remains o during exercise.
If the light is lit steadily during standby, the running surface material does not require maintenance.
If the light ashes during standby, the running surface material is beginning to show signs of wear.
If, during standby, the light ashes intermittently with groups of ashes, you must contact the Technogym Technical Support service for maintenance
to be carried out on the materials.
To Next Page
Loading...
