Run 1000 - Run 600 Excite
29
Run 1000 Run 600
A
A
B
B
Aligning the treadmill
When the equipment is running the treadmill must be centrally aligned in relation to the frame (i.e. the writing on the belt must be equidistant from both
sides). If it tends to move to the right or left or is not centrally positioned, it needs aligning.
The alignment is done with the equipment running.
Turn the adjustment screw (A), on the side shown in the illustration, using the supplied tool (B), until the writing is equidistant from both sides.
W
The treadmill realigns slowly: turn the adjustment screw ¼ or ½ a turn and then check the result before turning it again.
To Next Page
Loading...
