Run 1000 - Run 600 Excite
35
Run 1000
Run 600
Monitoring the heart rate
The equipment is able to measure heart rate trends,
in two dierent ways:
- with a device applied to the handle (hand
sensor), that switches on when you grip the
handles in the sensor region;
- with a chest band with a heart rate transmitter (Polar T31).
There must be no more than one transmitter in the reception range: otherwise the receiver
may receive dierent signals at the same time and give incorrect heart readings. If there
are several equipment units with heart rate receivers in the same area, the recommended
minimum distance between them is 80 cm.
Heart rate readings will not be accurate near electromagnetic radiation sources (TVs,
cellphones, etc.).
Should you have any doubts about the accuracy of the readings, contact the Technical Support
Service.
To Next Page
Loading...
