Technogym SYNCHRO ARTIS - Electrical Connection

19
SYNCHRO ARTIS
A
ELECTRICAL CONNECTION
Before connecting the product to the mains power supply, ensure that the
electrical system specications comply to binding regulations. Verify the main
power supply specications on the label axed close to the main switch.
Open panel (A) to reach the label and connector: put a nger in the hole and pull.
W
The wall socket must be located in a place where the plugging and
unplugging can be done easily and safely.
When plugging in, the power supply switch must be in the 0 position
(the equipment must be switched o).
Check the state of the power supply cable periodically.
Plug the power cable into the product socket rst and then into the wall socket.
Close panel (A) putting the cable through the slot.