Technogym VISIO E0000236 - Electrical Connection

TECHNOGYM VISIO 32” Pre-Installation Requirements
Rev. 1.0
- 16 - PIR-00328-EN - Uncontrolled copy if printed
4.2 ELECTRICAL CONNECTION
Before connecting the product to the mains power supply, ensure that the electrical system
specications comply with current regulations. Check the specications of the power supply on the
product’s identication label.
Remove the cap covering the connector.
Connect the power supply unit to the product rst and then plug it into the wall socket.
Put the cap back in place.
Fig. 6
WARNING: Check the power supply unit periodically to verify its integrity. The wall
socket must be located in a place where the product may be easily and safely plugged
in and unplugged.