Technogym VISIO E0000236 - Network Design - Configuration and Installation; Introduction; NETWORK DESIGN and PREPARATION PHASES (Business-To-Business (B2 B)); CONFIGURATION and INSTALLATION (Business-To-Business (B2 B))

TECHNOGYM VISIO 32” Pre-Installation Requirements
Rev. 1.0
- 9 -PIR-00328-EN - Uncontrolled copy if printed
2. NETWORK DESIGN – CONFIGURATION AND
INSTALLATION
2.1 INTRODUCTION
▪ Installation and conguration of the network infrastructure (cables), of the network hardware
(Switch, Router, rewall) and any wireless network are at the expense of the customer.
▪ Technogym warns that the e󰀩ciency and correct operation of the equipment and of the My-
wellness Cloud services depend on the technical characteristics of the hardware that is in-
stalled.
▪ Technogym does not guarantee the correct operation of the Mywellness Cloud services in the
event of failure to comply with all the technical specications and warnings indicated.
2.2 NETWORK DESIGN AND PREPARATION PHASES
(Business-to-Business (B2B))
During the network design and preparation phases, Technogym requests to be put in touch with
the technicians of the company performing the work, in order to obtain and provide technical infor-
mation, so that the network is installed and congured according to the required technical require-
ments.
Technogym can not be held responsible for failures due to site preparation, assembly and installa-
tion not correct.
2.3 CONFIGURATION AND INSTALLATION (Business-to-
Business (B2B))
Before performing the installation, the customer should inform Technogym that all the required
components have been provided and installed and that they operate correctly.
For this purpose, Technogym will contact the customer a few days before the date set for instal-
lation, to acquire the information related to the installation status of the network for the equipment
and thus check that everything that has been requested to perform installation of the equipment is
provided and operational.