EasyManua.ls Logo

Technogym VISIO E0000236 - Wireless Guidelines; FACILITY; HOTEL (Business to Business (B2 B)); HOME (Business to Consumer (B2 C))

Technogym VISIO E0000236
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TECHNOGYM VISIO 32” Pre-Installation Requirements
Rev. 1.0
- 20 - PIR-00328-EN - Uncontrolled copy if printed
Congure the Access Point to broadcast only one SSID (Service Set Identier) needed for the
equipment installation. The SSID must not be hidden;
Program in the display of equipment (Customer Menu 2406 --> Network-->Wi-Fi) just only the
SSID dened above;
Frequency Band:
_5GHz band only (not automatic) is the conguration suggested;
_If the Access Point is not provided with 5GHz band, 2.4GHz is ok but might need
some channel ne tuning by the local IT company. The best practice for 2.4GHz
Wi-Fi conguration is enabling Wi-Fi on one of the following channels: 1, 6, 7, 8, 9,
10, 11, 12. Other channels: 2, 3, 4, 13, 14 might cause interference with Bluetooth
signal and it’s best to avoid them.
_Avoid in any case to broadcast the same SSID, through 2.4 and 5 GHz, at the
same time.
LEASE TIME : at least three days;
SESSION TIMEOUT disabled (Typically achieved setting the timeout = 0).
For more details about Access Point (AP), refer to the AP technical specications.
5.4 WIRELESS GUIDELINES
The following indications must be interpreted only as guidelines.
5.4.1 FACILITY / HOTEL (Business to Business (B2B))
The wireless network should be installed and congured only by specialised companies and expert
technicians.
The equipment must not be more than 25-30 metres LOS (line of sight) away from the Access
Point (analyse possible problems due to the presence of walls or other obstacles between the
Access Point and the equipment).
If you use an Access Point with a xed channel: avoid overlapping problems if, in the same
area, there are Access Points that use the same channel.
5.4.2 HOME (Business to Consumer (B2C))
Make sure the wi- signal is reachable by the equipment.
If you use an Access Point / Wi-Fi router with a xed channel: avoid overlapping problems if,
in the same area, there are Access Points / Wi-Fi routers that use the same channel.

Related product manuals