Technogym VISIO E0000236 - Network Requirements; Introduction; Ethernet Cabled Network; Wi-Fi Network Requirements

TECHNOGYM VISIO 32” Pre-Installation Requirements
Rev. 1.0
- 19 -PIR-00328-EN - Uncontrolled copy if printed
5. NETWORK REQUIREMENTS
5.1 INTRODUCTION
TECHNOGYM VISIO 32” supports both wireless and wired internet connection.
In all cases, the network must be installed and congured by the customer before Technogym deliv-
ers the product, in accordance with the technical specications set out below.
5.2 ETHERNET CABLED NETWORK
Connect the product to the wired network, taking into account the following requirements:
• LAN Ethernet 10/100;
• Category 5e/6 - UTP Ethernet cables with RJ45 patch;
• Switch with a number of ports greater than the number of product connected.
It’s necessary to remove the coupler from the rear casing of the display, to connect the LAN cable
to the equipment.
Remove the two screws (TOOL: Hexagon key wrench 2.5 mm).
5.3 WI-FI NETWORK REQUIREMENTS
5.3.1 BUSINESS TO CONSUMER (B2C)
Connect the product to the Wi-Fi network, taking into account the following requirements:
• Standard: IEEE 802.11 a/b/g/n/ac at 5GHz or 2.4GHz;
• Security Protocol: WEP, WPA/WPA2, open (free) network;
5.3.2 BUSINESS TO BUSINESS (B2B)
Connect the product to the Wi-Fi network, taking into account the following requirements:
• Standard: IEEE 802.11 a/b/g/n/ac at 5GHz or 2.4GHz;
• Security Protocol: WEP, WPA/WPA2, open (free) network
• There must be only one dedicated Access Point / Wi-Fi router that provides the service;
• DHCP enabled;
• It’s recommended to avoid broadcasting the same SSID, through 2.4 and 5 GHz, at the
same time.
In case of professional Access Point or if the equipment is used in a public / company network (ho-
tel, tness facility) you must cover the following additional requirements: