Page 22 sur 26
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
1st level
troubleshooting
Contact the After-Sales
Customer Service Team.
Error code 11: No impact.
Check stylus/part distance.
Contact the After-Sales
Customer Service Team.
Error code 12: Abandonment.
The current marking operation
has been interrupted.
Restart the marking and check
at which point it was
interrupted.
Error code 13: No marking
head.
The marking head has not been
correctly connected to the
controller.
Check that the head has been
connected correctly and that
the connector is locked and and
restart the controller.
The marking head cable is
broken.
Check the condition of the
cable.
This may only occur when
initialising the marking
controller.
A mechanical blockage is
preventing the machine from
moving to its original position.
Check that there is no object
blocking the trajectory of the
striker unit and restart the
controller.
Turn the power off and check
that the machine can move to
its original position without any
problem.
The detection card is defective.
Contact the After-Sales
Customer Service Team.
Error code 14: X and Y origin
error.
The striker unit has been
mechanically blocked by an
external element.
Check that there is no object
blocking the trajectory of the
striker unit and restart the
controller.
To Next Page
Loading...
