Technomark M4 inline - Page 23

Page 23 sur 26
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Modèle du 06/11/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
 Error code
 1st level
troubleshooting
 Remedial action
May occur only after an initial
or nth marking.
The detection elements are
defective.
Issue with the sequences or
machine settings.
Check that the detection pins
are not twisted and thus unable
to pass through the sensors.
Restart the controller.
Check the status of the I/O
configured in the controller and
the condition of the sensors.
The detection card is defective.
Contact the After-Sales
Customer Service Team.
Error code 15: X origin error.
The striker unit has been
mechanically blocked by an
external element.
Check that there is no object
blocking the trajectory of the
striker unit and restart the
controller.
May occur on start-up, after an
initial or nth marking.
The detection element X is
defective.
Check that the detection pin X
is not twisted and thus unable
to pass through the sensor and
restart the controller.
The detection card is defective.
Contact the After-Sales
Customer Service Team.
Error code 16: Y origin error.
The striker unit has been
mechanically blocked by an
external element.
Check that there is no object
blocking the trajectory of the
striker unit and restart the
controller.
May occur on start-up, after an
initial or nth marking.
The detection element Y is
defective.
Check that the detection pin Y
is not twisted and thus unable
to pass through the sensor and
restart the controller.
The detection card is defective.
Contact the After-Sales
Customer Service Team.
Error codes 39, 40, 41, 42:
EEPROM errors.
Contact the After-Sales
Customer Service Team.