TECNA WELD TESTER TE1700
The device exports weld spots statistics from the pen-drive's internal
memory, if used. The quantity and type of saved data change,
depending on whether the NORMAL or ADVANCED statistics mode is
used. In both cases, a .CSV (Comma-Separated Values) file is saved
containing the numeric values of each spot relating to the quantities
measured and the instrument configuration. In ADVANCED mode, in
addition to data described above, an additional .CSV file is created, for
each weld spot, containing the numeric values describing the time
trend of the quantities acquired in a single welding spot.
WARNING: saving data in ADVANCED mode and a high number of
spots can take a long time.
The following icon appears during data saving.
WARNING: Do not remove the pen-drive during data writing
operations; just wait until the icon disappears. If you remove the pen-
drive before the write operations are over, stored data may be lost.
PAGE 42
To Next Page
Loading...
