TECNA WELD TESTER TE1700
7.0 ERROR MESSAGES
Signalling detection of a new transducer connected to
the instrument. It should be
configured correctly before
use.
Signalling input current over the selected rate. Switch to
higher rate or use a transducer with lower sensitivity.
Signalling input force over the selected rate. Switch to
higher rate or use a transducer with lower sensitivity.
Signalling input voltage over the selected rate. Switch to
higher rate or use a transducer with lower sensitivity.
An attempt was made to save a file to pen-drive but it
has not been inserted correctly or its format is not
supported. Before saving the file, ensure the pen-
correctly recognised.
PAGE 67
To Next Page
Loading...
