TECNA TE1700 - Page 66

TECNA WELD TESTER TE1700
3 LIMIT NUMBER 1 MAX: For setting the maximum value of the first
mask limit.
4 LIMIT NUMBER 2 TYPE: For selecting the type of control in IK, ENE,
TIME, FORCE or ID for the second mask limit.
5 LIMIT NUMBER 2 MIN: For setting the minimum value of the
second mask limit.
6 LIMIT NUMBER 2 MAX: For setting the maximum value of the
second mask limit.
7 LIMIT NUMBER 3 TYPE: For selecting the type of control in IK, ENE,
TIME, FORCE or ID for the third mask limit.
8 LIMIT NUMBER 3 MIN: For setting the minimum value of the third
mask limit.
9 LIMIT NUMBER 3 MAX: For setting the maximum value of the third
mask limit.
WARNING: Two LIMIT NUMBER TYPE fields having the same quantity
cannot exist inside one mask.
PAGE 66